dondford
10-02-2006, 06:13 PM
I am shipping a CZ 527 to Kevin Weaver tomorrow for converting to a 20 VT; I have a set of Hornady dies and Rem. 221 FB brass due any moment. My question is the best method to form the brass>
Should I just run it through the FL die? If so, should I remove the expander first?
Or run it through the seating die? If I use the seating die, should I remove the drop-down bullet guide,as well as the spindle?
I wouldn't think annealing would be needed, correct?
Any other tips appreciated.
Don
Should I just run it through the FL die? If so, should I remove the expander first?
Or run it through the seating die? If I use the seating die, should I remove the drop-down bullet guide,as well as the spindle?
I wouldn't think annealing would be needed, correct?
Any other tips appreciated.
Don