malahini40
12-22-2011, 11:44 PM
Hi Gang,
Looking to buy a 219 Donaldson Wasp sizing die. I got a Ruger #1 in some oddball chambering that works out to be "about" a 219 Donaldson Wasp necked up to 7mm. "Ideally" I would like to get an old Herters Wasp die and then drill it out to the proper dimension for a 7mm and then load for this thing. I have made brass for it using 7mm BR Remington dies and 30-30 cases but it [7BR die] will not full length size the case and I foigure, when I go to higher pressure loadings , it`ll need Full Length sizing. Of course if you got a better idea let me know too. Appreciate the help.
Aloha, Mark
Looking to buy a 219 Donaldson Wasp sizing die. I got a Ruger #1 in some oddball chambering that works out to be "about" a 219 Donaldson Wasp necked up to 7mm. "Ideally" I would like to get an old Herters Wasp die and then drill it out to the proper dimension for a 7mm and then load for this thing. I have made brass for it using 7mm BR Remington dies and 30-30 cases but it [7BR die] will not full length size the case and I foigure, when I go to higher pressure loadings , it`ll need Full Length sizing. Of course if you got a better idea let me know too. Appreciate the help.
Aloha, Mark