Liseo
12-23-2015, 08:05 PM
Hi
I have a set of Blackmom steel dies who make very good 52 grains FB bullets, on par with Sierra and Berger.
Today adjusted the core weight to make 73 grains bullets on .930" J4 jackets.
But I noticed that the core dont slip down to the botton of jacket, staying at least .250" above .
My concern is that I will have air trapped under the core.
So,I am worrying for nothing or it would be better to use a smaller diameter core, allowing it to touch the jacket botton?
I need a BR quality bullets.
What you think?
**Excuse my bad english
I have a set of Blackmom steel dies who make very good 52 grains FB bullets, on par with Sierra and Berger.
Today adjusted the core weight to make 73 grains bullets on .930" J4 jackets.
But I noticed that the core dont slip down to the botton of jacket, staying at least .250" above .
My concern is that I will have air trapped under the core.
So,I am worrying for nothing or it would be better to use a smaller diameter core, allowing it to touch the jacket botton?
I need a BR quality bullets.
What you think?
**Excuse my bad english