Quote:
Originally Posted by fatboy
After measuring I believe that the problem would be the pillars are too short. I believe I can make a spacer, or was thinking about using the bedding as a filler on the bottom of the stock, in the hole. Think a spacer would be best. I believe either way, I may still have to bed, under the trigger guard, and the front mag plate. I like remingtons.
|
That is what I suspected after talking to a couple friends. What I would do is get a couple bolts that fit and use electrical tape at the action end and a compression washer for copper water feed line at the other end to center the pillars and nuts and washers to hold them in place while you glue both pillars in place in the stock. Then I would bed the action and floor plate using Devcon Steel.