View Single Post
  #10  
Old 05-28-2013, 03:11 PM
ben lurkin ben lurkin is offline
Senior Member
 
Join Date: Nov 2012
Location: Tooele, UT
Posts: 222
Default

Quote:
Originally Posted by Danny View Post
I am leaning more towards selling rather than forming, at this point, but may still consider it. If the political conditions were not as they are, causing shortages, I would not consider forming. However, I still need to round up dies, and the case holder for my Wilson trimmer, among other things I need for other projects. By that time, brass could be more readily available.

Danny
That's a good decision! Despite the brass being "free", by the time you get forming dies you will be upside down with this project from a cost standpoint. Sell or trade the 308 brass for some 22-250. 22-250 can still be found if you're a bit patient. I just picked up 400 for my son at pre-crazy prices but it took a few weeks for thr right deal to come along. Besides, I like having the proper headstamp on my brass (excepting my wildcats of course)
Reply With Quote