I used a 226 bushing because that is one of the 20 calibre bushings I had on hand for loading the 204 and 20 VT. I have from .224 to .227. Thus if you order 224 - 227 you can use them if you ever get a 20 cal to load for and you can load 20 VT using the same neck S die as the 17 FB.
As to using a piece of brass to wear the metal tit that is scratching, that metal is very hard and will never wear away from the brass running over it. Even with the grinder head it took quite a bit of rubbing to get rid of it completely.
Last edited by Dean2; 04-14-2014 at 12:51 PM.
|