#1
|
|||
|
|||
14x28
Anyone doing this? Itried the search engine and no joy. For clarification this would be a 5.7 x 28 necked down to .14 Thanks, dedogs
__________________
I try not to let what I DO know about shooting and re-loading prevent me from learning something I DON'T Last edited by dedogs; 09-28-2016 at 04:24 PM. |
#2
|
|||
|
|||
Hmmm, you had my brain cross threaded
until l read further. Maybe:. .14x28 would-be mo' clear?
|
#3
|
|||
|
|||
Fixed it. Thanks for the heads up, had a brain fart when I posted this.dedogs
__________________
I try not to let what I DO know about shooting and re-loading prevent me from learning something I DON'T |
#4
|
|||
|
|||
+- ½grain H2O it will be on par with the .14 Walker Hornet but QL has no .14 bullets so i have trouble making some WAG
|
#5
|
|||
|
|||
You can add them pretty easy. If you need lengths let me know and I'll send them to you. Just go up to 'Data'>'Projectile'>change data in active record
It will pop up a screen, enter the data, and click 'add new' and there it is.
__________________
Ron Reed Reed's Ammunition & Research, LLC www.reedsammo.com Main Page http://shop.reedsammo.com Online store info@reedsammo.com |
#6
|
|||
|
|||
I am sure it has been done, most things have. I think the 14TCM holds about as much powder as is reasonable to burn in a 14. Larry
__________________
A gun is just like a parachute, if you really need one, nothing else will do. |
#7
|
|||
|
|||
Quote:
I was thinking that you would need tweezers to put a 14mm case into a shell holder. John |
#8
|
|||
|
|||
The FN brass is polymer coated and rather thin, not a high pressure round. There is some aftermarket brass being done, thicker than FN-
http://www.eliteammunition.com/store...Pcs/p/64115523 |
#9
|
|||
|
|||
DeDogs:
Sending you an apology for my former comment. Tried to back then but, the posts had been dumped due to 20extreames flaming. Don't worry about the coating on the FN brass. Just put it in the shaker til it all comes off. Clean brass is good stuff. Just be real careful when priming them as there's almost no lip on the case for the shell holder to catch on, they'll pull right off real easy. IF you can, get the 4.4mm x28mm brass. foxhunter can tell you where to get it. I haven't seen any of that yet. When the getting was good and cheap enough I got about 4000 of the FN's. IF you run into problems finding brass to use at first, let me know and I'll be happy to donate a couple hundred. Good to see you back.
__________________
George "Gun Control is NOT about guns, it's about CONTROL!!" |
#10
|
|||
|
|||
this is why i love this site no bs just pl trying to help pother pl,
Im sure this was done mate around the time there was some 17 stuff being done in the same case. best of luck with it |
Thread Tools | |
Display Modes | |
|
|