#1
|
|||
|
|||
Martini and glass mounting option question
Finally got around and found a piece of glass for my martini.
A Redfield 3200 in 16x found its way to my door today. I have an old weaver rail that came with the rifle. Any suggestions on anyone that makes a nice rail for a Martini. Would like to see if there is any other options out there. Last edited by albertacoyotecaller; 02-20-2017 at 08:10 PM. |
#2
|
|||
|
|||
Reading that header i thunk of James Bond.
|
#3
|
|||
|
|||
Yeah...I was about to get some olives!!!!!!
__________________
"Burn Powder, Not Comrades"! |
#4
|
|||
|
|||
Sry- I used a Weaver long base, one screw into the barrel, one in to the front action ring. .22 ACK Hornet only.
__________________
Daryl |
#5
|
|||
|
|||
The barrel is drilled and tapped for the original base used but if I remember it was a cheap skinny Weaver base. Just looking for something more refined. I have seen others that have some custom bases but can't find the websites anymore.
Just throwing it out there as the knowledge here is as good as anywhere and I am sure I will be steered in the right direction. |
#6
|
|||
|
|||
bases
The TC Contender base is a nice 1pc that cantilevers back over the action, allowing you to move your rear ring further back. Of all the 1pc options this is my favorite. I then use the Burris Zee rings with the inserts, allows me to adjust the scope so I do a minimum amount of turret twisting when sighting in. For a vintage look you can go 2pc Talleys, or the 3/8's dovetail gives you a lot of options also.
|
#7
|
|||
|
|||
1pc bases
Here's a pic of a TC base on my 17HMR with a set of Warne Maxima rings. I've since replaced them with Burris Zee's, the Warne's are a little clunky looking but it shows how you can move your rear ring back.
|
#8
|
|||
|
|||
My turn.
Weaver 92 A mounted so it extends over the receiver ring
__________________
Douglas, Gopher Damage Mitigator, Retired |
Thread Tools | |
Display Modes | |
|
|