#1
|
|||
|
|||
model 700 in 22 hornet
Did Remington ever make one or a caliber with a 22 hornet size bolt face?
|
#2
|
|||
|
|||
not in a factory chambering for the 700 , at one time PTG offered a replacement 700 bolt with a Hornet bf
the Rem 799 (Zastava mini mauser) rifle was offered in 22H
__________________
Small Caliber Reloading - So easy a Caveman can do it ! www.raginblaze.com .... Cajun Seasoning with a SouthWest Flare |
#3
|
|||
|
|||
22 hornet bolt face
Thanks for the reply. I contacted PTG today. No longer available through them. I'll keep looking.
|
#4
|
|||
|
|||
It wouldn't be to difficult to bush it and put a sako in.
Adam |
#5
|
|||
|
|||
What would one expect to pay for something like that ab?
|
#6
|
|||
|
|||
+1 what Adam says, that's exactly what my smith did for my first 17 Badger
|
#7
|
|||
|
|||
Bob Green did an XP-100 bolt for me by bushing it and putting in a sako. I think it was about $125ish. Been a while so I don't really remember. But mine is a bit different because I had him make it so it would pull both 20TAC and 17 Ackley hornet cases. Never had an issue with it.
Aaron |
#8
|
|||
|
|||
$125, most smiths are right at that mark.
Adam |
#9
|
|||
|
|||
is the sako bolt readily available in 22 hornet bolt face and where should I look?
|
#10
|
|||
|
|||
Model 700 in 22 Hornet
believe you must mill out/off the face of the bolt, and reface and mill in the Sako extractor.. Adam, Green and other's can and will do the job, just fine. Bill K
|
|
|