|
|
|
| |
|
#3
05-08-2014, 11:53 PM
|
|||
|
|||
|
|
#6
05-09-2014, 12:05 AM
|
|||
|
|||
|
Quote:
Boy that's always a sticky one. From a blank, hand cut, minimum would run around $1000 plus blank. Now if you had a pattern stock and blank turned it would run you around $300 to fit and finish the stock. I would recommend Jacks Mountain Gunstocks. That's who rayH uses. Adam
|
|
#9
05-09-2014, 02:53 AM
|
|||
|
|||
|
Quote:
__________________
Shoot First... Ask questions later... On Saubier.com __________________ NRA Lifetime Endowment Member
|
|
#10
05-09-2014, 02:57 PM
|
|||
|
|||
|
CZ stock
Here are some pics of stocks that have oil on them. These came off Ray H's pattern that I had Mark Weider add 1" to the butt. First is my 17 Rem and second is a 17 Spartan (17FB .200 short), on the 17 Rem the forearm has been rounded a little as the pattern is flat. Third pic is of the stocks I had turned, the maple is now owned by a Saubier member. If you can do a lot of the labor you can come up with something pretty cheap like these. I don't have 50.00 in any of the blanks, add the cost to turn plus labor to finish.
17Rem Varmint - factory barreled action  17 Spartan w/Benchmark barrel   The 3 stocks fresh back from Mark Weider 
|
 |
|
|
Linear Mode
