#11
|
|||
|
|||
Quote:
Still, 30 seconds of checking the bolt engraving/serial number will eliminate this issue. Time well spent, maybe. Stuff happens.............. -BCB
__________________
I miss mean Tweets, competence, and $1.79 per gallon gasoline. Yo no creo en santos que orinan. Women and cats will do as they please. Men and dogs should relax and just get used to the idea. Going keyboard postal over something that you read on the internet is like seeing a pile of dog crap on the sidewalk and choosing to step in it rather than stepping around it. If You're Afraid To Offend, You Can't Be Honest - Thomas Paine |
#12
|
|||
|
|||
The bolt matches the rifle. The extractor seems out of place or weak. I was moving it with a dental pick and it seemed really weak. Will change it.
|
#13
|
|||
|
|||
Rem 700 extractor issues
Quote:
Now when you replace it, let is know for sure that, that was it. More often than not, a fix is very simple. And many make a mountain out of a molehill.. D Bill K |
#14
|
|||
|
|||
Quote:
From the git-go, the extractor seemed to be a likely cause and it is an easy fix. Not as simple as checking a bolt serial number, but still a very likely cause of your problem. If a new extractor doesn't cure the problem, then bolt timing becomes an issue to look at. A good smith can deal with that issue for you. Always eliminate the easy things first, and only try one "cure" at a time so you can truly isolate the problem............. A simple process of elimination from the easy to the harder and perhaps more costly fixes. Everythig suggested to this point could be or could have been an issue worth looking at. -BCB
__________________
I miss mean Tweets, competence, and $1.79 per gallon gasoline. Yo no creo en santos que orinan. Women and cats will do as they please. Men and dogs should relax and just get used to the idea. Going keyboard postal over something that you read on the internet is like seeing a pile of dog crap on the sidewalk and choosing to step in it rather than stepping around it. If You're Afraid To Offend, You Can't Be Honest - Thomas Paine |
#15
|
|||
|
|||
I compare it to another Remington extractor. This one is loose in the bolt face when I pick at it with a dental pick and rotates/shifts easily. I will get it changed out and I am sure it will be fine. I haven’t owned a lot of Remington rifles over the years so it’s just a new issue to me.
|
#16
|
|||
|
|||
Quote:
The concern I'd have is you mentioned there wasn't any problem/s, that you were aware of at least, before you had any smith work done. |
#17
|
|||
|
|||
Yes that is a concern for sure.
|
|
|