Saubier.com  



Go Back   Saubier.com > Saubier.com Forums > Small Caliber Discussion Board

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 04-13-2012, 05:23 PM
Alycidon Alycidon is offline
Senior Member
 
Join Date: Jul 2007
Location: England
Posts: 1,071
Default 17 Hornet rim thickness.

Does anyone true the rims of these cases ?. Measure new cases rim thickness with a mic and you get some disturbing variations, I have had considerable side to side variations on the same case.

My 17AH shoots about MOA using Remmy brass straight out of the box and annealed before and after forming which is fine for a short range vermin rifle, but a bit of fine tuning could halve that.

Has anyone lathe turned the rims on the neck side to a consistent thickness
, if so what accuracy results did you get compared to non turned cases?.

A
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 11:04 AM.


Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.